A Quick Tour of an EQ Mount

From McWiki
Jump to: navigation, search

Setting Up an Equatorial Mount: A Quick Tour

To begin our discussion of setting up an equatorial mount, we will have a little tour of a typical mount. There are many kinds of equatorial mounts, but most share some common features such as those found on this Stellarvue M4 mount. We'll use this M4 as a guide for most of this article, occasionally showing differences on other mounts. m4Posed300.jpg
Equatorial mounts (EQ mounts for short) are immediately recognizable by the way they hold the telescope tube at an angle tilting upward, and by the shaft, holding a counterweight, that hangs under the mount at right angles to the telescope tube. m4Posed300Counterweight.jpg
If you draw an imaginary line through the mount at a right angle to the counterweight shaft, you define the polar axis. This part of the mount will be aligned to point to the North Celestial Pole (NCP), and it does not move, even when the telescope is moving in the other directions in which it can.

What seems like extra complexity in EQ mounts will become simpler if you remember that the whole point of an EQ mount is to get, and keep, this axis pointing toward the NCP. We'll discuss how to do this in a later article.

m4PosedPolarAxis.jpg
EQ mounts can move the telescope in two directions (both of which trace circular paths, and neither of which is similar to the directions we normally use on Earth). First, it can rotate around the polar axis. Such motion is called Right Ascension (RA for short).
m4-ra-anim300.gif

Next, it can rotate around the direction defined by the counterweight shaft. This motion is called Declination.

Summary:  Move the telescope; if the counterweight is moving, that is Right Ascension.  If the counterweight is not moving, that is Declination.

m4-dec-anim300.gif
By combining these two motions, the telescope can be pointed anywhere in the sky. ra-dec-anim.gif
Somewhere on the mount there will be knobs which, when tightened, prevent the scope from moving in these directions. One to lock RA motion, one to lock Declination motion. RA-dec-locks.jpg
On some mounts (all non-motorized mounts and some motorized ones) there will be two flexible shafts with knurled knobs. These are slow-motion controls for the RA and Dec motions. The mount can be moved by these controls even when the locking knobs shown above are tightened - those are only for locking big "by hand" movement. In fact, the slow-motion controls are supposed to be used with the other locks tightened. slowmo-ctls.jpg
The above RA and Dec controls are for moving the telescope on the mount. There are usually also two controls for moving the mount itself, used when polar aligning it. These controls may be harder to access since they are used less often. There will be one set of knobs for moving the mount left and right a small amount, and another set of knobs for raising and lowering the elevation of the polar axis. m4-align-controls.jpg

There is usually also a scale somewhere showing the current elevation of the polar axis in degrees. The elevation is usually set to your latitude on Earth (or close to that, adjusting for lack of levelness in the mount), so this is generally called the "Latitude Scale". We'll discuss this when we discuss polar alignment.

Again, these controls are not used to point the telescope, they are used to align the mount. You'll use them infrequently - typically only when you set up your mount the first time, or if you disassemble it or move.

m4-lat-scale.jpg
There may be additional knobs to lock the mount against motion in these directions after it is adjusted. latitude-lock.jpg
Finally some mounts will have one or two small DC motors used to smoothly drive the RA and possibly the Declination motions. Usually these are optional on smaller mounts and standard on high-end mounts. m4-ra-motor.jpg

Next

 
Up to Equatorial setup article



Back to Astronomy Writings Up to Richard's Astronomy Section Back to Setting Up article

Comments?

You need JavaScript enabled for viewing comments